• CO2 (Carbon Dioxide) Logger Sensor - Edu-Logger

  • 900-230
  • In Stock
  • Add to favourites

  • £240.35excluding VAT

    £288.42 including VAT

  • This logger sensor is based on an electromechanical reaction between CO² gas and the sensor.


    The result of the electromechanical reaction is voltage, measured by the logger sensor. The measurement units are ppm (parts of CO² per million of air).


    As with all Edu-Logger Sensors this must be used with the Edulogger USB module or the Wi-Fi module

    View full details

    • Bullet Point Converts the measured parameter into a processed value (°C, °F, Lux, dB, mA, V, etc.)
    • Bullet Point Sends the data in digital form to a viewer unit, any kind of computer or tablet
    • Bullet Point Saves up to 5 experiments in its flash memory
    • Bullet Point Calibration is done by pressing a push-button
    • Bullet Point Changing ranges and gains is done through software
    • Bullet Point Experiments run with or without a computer
    • Bullet Point Saved experiments in the Logger Sensor can be uploaded to a computer at any time
    • Bullet Point The modular plug and play system allows the connection of sensors in a chain, in any order
    • Bullet Point Each sensor is in itself a full data acquisition system
    • Bullet Point Unbeatable value for money
    • Bullet Point Robust hardware and attractive design
    • Bullet Point Very simple operation
    • Bullet Point No cable clutter and therefore a very simple construction of experiments
    • Bullet Point System allows wireless connection
  • Nobody has left a review for this product yet, be the first to do so. Leave Review

Technical Specification


Experiment Duration: 1 second to 31 days.


Range and operation modes:-         

350 to 10,000 ppm


ADC resolution

14 bit



1 ppm


Max Sample Rate (S/sec):-   

100 (subject to experiment duration)



The sensor must be calibrated before every use according to the following simple procedure:

  • Connect the sensor to the PC through a USB module or to a battery module.
  • Wait for two minutes to warm the sensor and press the pushbutton on the CO² logger sensor for 3 seconds.
  • A bottle adapted to the sensor is supplied.

Product Reviews

Nobody has left a review for this product yet, be the first to do so.

Leave a review